SuperSpeed USB 3.2 Gen 2x2 (20 Gbps) Performance Note: USB 3.2 Gen 2 (10 Gbps) is also know as USB 3.1 Gen 2 (10 Gbps), and USB 3.2 Gen 1 (5 Gbps) is also know as USB 3.0 and USB 3.1 (5 Gbps). The USB-C port provides up to 15W (5V/3A) of power and is backward compatible with USB 3.2 Gen 2 (10 Gbps) and USB 3.2 Gen 1 (5 Gbps) devices. The USB-C port is ideal for connecting USB devices such as external hard drives and solid state drives or charging and syncing your mobile devices. The controller card enables you to connect USB-C Gen 2x2 (20 Gbps) devices to your desktop computer.
This PCIe USB 3.2 Gen 2x2 controller card installs into an available PCI-Express x4 slot in your computer and enables you to upgrade your current system by adding a USB-C (20Gbps) port.Īdd a 20 Gbps USB Type-C Port to Your Desktop Computer
USB 3.2 Gen 2x2 (20 Gbps) PCI-Express 3.0 PCIe x4 Slot USB Type-C.
PIN 52 - Optional PIN for 3.3V + (you may skip this and your card will still working)Īfter all step in the previous is done than it's time for us to test it by PLUG in to the USB port (wait for a sec until your PC detecting new device) and EUREKA.the PC is detecting the modem, now just wait for us to load the proper driver of the CARD. PIN 16 - This is connection for the SIM CARD Vpp - THIS WILL CONNECT TO THE SIM CARD PIN 5 PIN 14 - This is connection for the SIM CARD RESET - THIS WILL CONNECT TO THE SIM CARD PIN 2 PIN 12 - This is connection for the SIM CARD CLOCK - THIS WILL CONNECT TO THE SIM CARD PIN 3
PIN 10 - This is connection for the SIM CARD INPUT / OUTPUT PORT (I/O port) - THIS WILL CONNECT TO THE SIM CARD PIN 6 PIN 8 - This is connection for the SIM CARD VCC - THIS WILL CONNECT TO THE SIM CARD PIN 1 PIN 4 - This is connection for the SIM CARD Ground PIN 2 - This is the 3.3V (+) this is from the OUTPUT line of LM1117 chip that we create in the previous step. Here I am describe each even number of the card pin detail : Just follow my image (orientation) that I provided bellow to determine the PIN NUMBER of the cardĬounting from the RIGHT (you see the image on your monitor) and the small legs of the card is also located on the RIGHT, the TOP section of the card is begin from PIN 2,4,6,8,and ECT (even numbers)īy this way you can easy to locate what pin number of your card (even some card have a number on the above of it's pin).Īnd Here I am also attaching the PIN NUMBER detail for the MINI PCI-e Connector (as shown on the table bellow)
After the Power supply are done and it's run 3.3V (tested by volt meter), the next step is preparing the card by soldering the wire in to the require pin.īy using the USB D+ and USB D- pin from the card ( which is identified in pin 38 for D+ and 36 for D- ) and connect this pin by soldering the wire from USB cable (most usb cable has a std in the color Which is GREEN WIRE COLOR is for D+ and WHITE WIRE COLOR is for D.